![]() ![]() Mode Programmer (Programming Track) Setup window opens (error code 308 inĬlick on Service Mode (programming track) Programmer and the Service The ack is not seen by the DCS it says the decoder did not respond. When the write hasīeen successful the decoder will acknowledge (ack) to the Digital Command Station (DCS.) If The CV data is written to ANY and ALL decoders on the programming track. Writing to Decoder on the programming track: If theĪck is never received the Command Station tells DecoderPro that the Decoder did not In agreement with what is in the CV of the decoder, the decoder will send an ack. When the Command Station sends the decoder data that is See the loco jump a bit as the decoder pulses the motor for "yes". WhenĭecoderPro is working it will show you what events are being performed. Word idle is normally shown when the programmer is inactive. The process by looking down at the bottom line of all the panes (the status bar) where the This can take a bit of time since the command station must askĪll possible values waiting for the yes response. The command station notices the currentīeing drawn and stops asking questions, since it got the yesĪnswer to the last question. Turns on the motor for only a very brief time. Instructions, so special instructions were developed which allow the Command Station toĭetermine the contents of the decoder's memoriesīasically the decoder is asked a whole series of questions and when the answer is "yes" it Mostĭecoders cannot talk to send information back to the command station. The decoder to respond to a query, what is known as Readback. To obtain information from the decoder on the programming track we rely on the ability of Reading your Decoder On the programming track: ![]() (not pleasant when you have an ops session in progress. Programming track, and some brands will shut down the mainline power when in programming mode Not all command stations support a dedicated ![]() Taken to the servicing track to be programmed). (Probably because the Locomotive has to be Locomotive on the dedicated programming track. Service Mode (programming track) Programmer - Select to program the Programming Track and Program from context menu.ĭouble clicking on a locomotive in the roster will open the Programming Icon in the DecoderPro® Tool Bar or by selecting locomotive from your rosterĪnd selecting Programming Track and pressing Program button.Īn alternate method is by right clicking on a locomotive in your roster and selecting The Service Mode Programmer is opened using the New Loco
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |